In July of 2017 a cottonwood came down during a thunderstorm and landed on the pipe fence of the horse corral with the tree canopy almost completely covering the corral. The horse was unhurt but trapped in the far corner of the corral. A friend came over the next morning before work to chainsaw enough of the tree so I could get the horse removed to another location. It took awhile to deal with the bee hive that had taken up residence in the trunk of the cottonwood but once that was accomplished, the rest of the tree was able to be cleared from the corral. That still left part of the trunk on the pipe fence itself but the remaining tree blocked the horse from getting out of the corral. A few weeks later, I was finally able to get the rest of the tree cut up and then used a piece of cattle panel as a temporary patch. Another friend with welding equipment and skills agreed to take a look and see if he could fix the fence. When he finally made it out, we talked about possibilities and I asked if, instead of replacing the two sections of fence that formed that corner, it would be feasible to cut out the damaged sections and replace it with a gate that fit diagonally across to the undamaged sections on either side. He went home and built a gate but it was over a month before he could fit in the time to bring the gate and his welding equipment out. Tonight, after a few mishaps, the damaged pipe and cattle panel was cut away and the new gate welded in place. It took over eight months, but everything is finally done – and I have two gates.